Product group: Rod seal
Design: DS V-packing set
Profile no.: 01
Specification: E suitable for one-sided pressure load
Model: 1/0 combination of fabric and elastomer ring
Seal material: NBR fabric NBR F 90 3005
Support ring: NBR fabric
Pressure ring: NBR fabric
Operational application limits
Pressure (MPa): ≤40
Temperature (°C): -30 to +100
Running speed (m/s): ≤ 0.5
Hydraulic oils acc. to DIN 51524 Part 1 – 3, lubricating oils, mineral oil based lubricating greases, highly non-flammable hydraulic fluids HFA, HFB, HFC acc. to VDMA 24317
The SDS 01 1/0 V-packing set is a sealing system with one fabric sealing ring. This combination is rarely used as a rod seal but provides the basis for the combination of individual set lengths. The V-packings are, due to their geometrical composition, always used in conjunction with the support ring and pressure ring. V-packing sets are used in extreme application areas.
V-packing sets are always installed in axially accessible installation housings. The rings are installed individually.
The V-packing set must not be compressed i.e. the L dimension and the H dimension should always be the same.
Please note that elastomer V-packings must always be installed between two fabric V-packings, as an elastomer V-packing should never touch a support ring or a pressure ring. Depending on the installation length available, the SDS 01 1/0 V-packing set can be supplemented by any number of individual V-pack rings.